Re: Finger Pulls on Drawer fronts
|
OK The search for a Capable Process has been pursued, using comments from the FOG Success and repeatability has been achieved The template was modified with a 30 mm overlap from the edge to allow a quick alignment and therefore a faster, more consistent feed rate Two routers used, bothe with template followers set so the one template could be used without changing. The first run was a straight cut bit to hog as much as possible, the second with a finger pull bit to quickly remove the final waste All good, still talking to my daughter BTW, it was recycled hardwood, 60 yrs old from a house I demo'd, it was building euc, therefore mixed south coast eucs, not easily identified. BTW2 Couldnt?see a difference with router speed, bear in mind the bits were 12mm and about 22mm ie small BTW3 Derek- I bought a plane from you many yrs ago- prob E?Bay Regards to all Tnx Bob
|
