As we're gearing up to get our mill and lathe my son is becoming exposed to David Best and after going through his flickr albums he tells me he knows why he's not David "Good Enough".
On Tue, Jan 5, 2021 at 8:43 PM David Luckensmeyer <dhluckens@...> wrote:
Which David B. ?? There can only be one David B. on FOG I think, and that is surely David Best.?
David Blehar, do you have a nickname?
I¡¯m David L., but I¡¯m glad I go by Lucky here. Too many David¡¯s!!?
Warm regards,
Lucky
(David Luckensmeyer)
On 6 Jan 2021, at 11:13 am, imranindiana via <imranindiana=[email protected]> wrote:
?
David B,
Thanks for sharing the roller height calibration #s.
Imran
On Jan 5, 2021, at 7:08 PM, David Blehar via <davidblehar=[email protected]> wrote:
?perhaps the feed rollers need an adjustment beyond just the spring tension? Most of you guys in this forum seem have this info already, but the specs I got from Felder when I tuned up my AD741 were as follows:
The infeed roller should be 0.020" below the bottom most rotation of the carbide insert. The outfeed roller should be 0.028" below. +/- 0.004
Maybe if the infeed and/or outfeed rollers are set too high they're not engaging the material properly to pull it through?
