The Holz Her is either made by Altendorf or uses their design.? Looks like a good price on the Altenburg too.? Large three phase machines are the best deal used if you can handle the amps and the three phase.? Often they are priced low enough to price in the
RPC and $1500 for parts.? I always assume a minimum of $1500 for replacement or motor work on sliding saws.? Dave
toggle quoted message
Show quoted text
Pretty sure that was just a saw, not a saw/shaper. In that vintage with obvious signs of tons of use/abuse, I¡¯d say more like $3000-$4000. Look around on Craig¡¯s List, Offerup and Facebook Marketplace, locally I have
a lot to choose from:
for $10,500 asking
for $7500
for $3600
and there was an Altendorf F45, but it looks like it must have sold, think it was under $7k, might have been $5k.
Don't these usually list for close to $15k new? Even though this certainly isnt "mint condition" it might be a good deal.?
Does anyone know what the going price is from Felder?
On Mon, Dec 14, 2020 at 8:27 AM Chris Perren <
cperren@...> wrote:
I thought the same¡? laughable.
?
Chris
?
?
"Mint condition, very nice"
I need to change the headline when I sold something online, like "better condition than new" :)
This looks like a crappy condition at a very high price to me.
Bill
