My first J/P was a 2008 A3-31 and the manual had a good section on how to adjust for planer snipe. I don't know if this is still in the newer manuals and I have long since upgraded. Perhaps if someone has one of the older manuals they could post the adjustments section.
On Mon, Oct 5, 2020 at 12:28 PM Cliff Rohrabacher, Esq. <
rohrabacher@...> wrote:
Sorry that didn't help.?? Maybe try looking for anything that
might not be bolted firmly. Snipe is the result of movement.? It
can be less than obvious? where the movement? originates.? Maybe
take the sheet metal off the sides of the cutter head and check
the bolts holding things in place.? Also? look to the table lock
make sure it is really locking the table.??
On 10/5/20 9:43 AM, Toni wrote:
Hey Cliff,
I always support my boards as the are fed through and exiting the
planer. This doesn't seem to resolve the snipe I am getting.
Thanks for your input?
