|
1. Its easier to leave rip fence unmodified so you know it is consistent. 2. Pick a spot on the slider travel you always index. I choose to slide mine all the way back until it hits the travel stop, then move stock across slider toward the rip fence until it makes contact. 3. Verify test cut is indeed what you want.if not, adjust rip fence width accordingly and verify it is now correct. 4. Wider stock will contact rip fence further back than narrow stock using this method because the rip fence toe out means the back corner of the stock will contact the rip fence, not the front. So adding John Kee's magswitch point block he showed in prior message will ensure consistency at that same bump stop point regardless of the stock width. 5. Don't worry about it anymore, you've mastered this task now. On Thu, Sep 24, 2020, 9:22 AM jontathan samways <jonathansamways@...> wrote:
|
