Re: Sticky table slie on CF 731
¿ªÔÆÌåÓýPaul, ¡°If I move the? rip fence close to the blade, say 50mm, the table slide becomes very stiff in the middle of its run. What gives?¡± I assume by table slide, you mean slider. if so, are you using rip fence in the above scenario as a bump stop? is the rip fence pulled way in front of the blade? imran On Aug 21, 2020, at 10:41 AM, Paul Mc Cann <tpmccann@...> wrote:
?If I move the? rip fence close to the blade, say 50mm, the table slide becomes very stiff in the middle of its run. What gives? I have a further problem which I keep putting off. If I tilt the blade to 45degrees the wood jams against the rip fence. I think I know how to solve this but just wondered is there any relationship between the two problems -- Paul Mc Cann |
imran