Re: C31
¿ªÔÆÌåÓýI was going to suggest to rerun the board after planning without changing table height. It should eliminate resistance from cutter or concern of cutting height. Imran On May 23, 2020, at 1:27 PM, Alex Bowlds <aabj@...> wrote:
?I agree with Brian, start with cleaning and waxing the table. ?That should improve your problem, but may not completely correct it. ?Then make sure your knives/cutters are sharp. ?They can also contribute to the problem. ?Do these things before you consider adjusting or replacing the pressure rollers. ?It wouldn¡¯t hurt to try to clean the feed rollers too. Good luck, Alex
On May 23, 2020, at 8:14 AM, Brian Lamb <blamb11@...> wrote:
|
imran