¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Felderownersgroup
  2. Messages
Single Messages Topics Expanded Polls

Re: #Knee Mills #knee

 

¿ªÔÆÌåÓý

I use my 3D printer a lot to test fit things, make fixtures to hold parts for laser engraving¡­ all sorts of things. I recently was helping my daughter on her kitchen remodel and she picked a three dimensional tile for her backsplash. It didn¡¯t work so well with the electrical outlet trims, so I used my 3D printer to make extension rings so we could tile up to a straight edge and then put the electrical trim on and have it look right.

Brian Lamb
blamb11@...

Before we installed the tile¡­.


After the tile¡­.



On Feb 13, 2020, at 8:25 AM, Mark Kessler <mkessler10@...> wrote:

We have been using 3d printing for 15ish years to iterate on designs but thats pretty much it, if we need a precise parts metal needs to be cut, even parts that come off our metal 3d printer are useless unless secondary operations are done with traditional machinery.?

Regards, Mark

On Feb 13, 2020, at 10:19 AM, Bill James via Groups.Io <xxrb2010@...> wrote:

?Mark you are an early adopter,

Not sure there are many people out there 3D printing stuff to get it produced somewhere else, but I like it,

Bill

Join [email protected] to automatically receive all group messages.