Hi David,
My 2016 Profile 45z x-motion has about 120mm of spindle travel.
At the lowest the spindle will go it sticks up above the table 46mm to the top of the spindle cap bolt.
Joe in New Orleans
toggle quoted message
Show quoted text
On Jan 28, 2020, at 3:17 PM, david slater via Groups.Io <
davidslater@...> wrote:
Hi Imran,
thank you for all the replies to my issue, I am sorry i did not reply I was unwell and have only just got back to my workshop and to the issues i was having
The problem was apparently an over-voltage issue relating to the replacement display being a newer model and not liking any over voltage whatsoever. In the end up i had to install an additional higher tolerance transformer to power only the display to eliminate the issue.
I now have to re calibrate everything due to the new display unit being installed and I wonder if anyone with this machine can tell me how much spindle travel they have? i.e should the spindle drop below the table completely? At its lowest setting mine still sits around 50mm above the table.
Thanks, David.
