开云体育

ok ---------- P?vodní e-mail ---------- Od: Clyde & Sheila Jones <clydeandsheila@...> Komu: [email protected] <[email protected]> Datum: 16. 5. 2025 14:28:03 P?edmět: Re:

Andrei two wholle sets you mean two wheels? ---------- P?vodní e-mail ---------- Od: Andrei via groups.io <calciu1@...> Komu: [email protected] <[email protected]> Datum:

At a price of 12 Euro (about 13 dollars), I would buy two whole sets. Who knows when such a buying opportunity will come again. Best Regards, Andrei mailto:calciu1@...

Regarding: "Any SAE 10 motor oil would work just fine, right?", the answer is NO. Typical "motor oil" (for cars) includes detergents to suspend dirt & particles to be removed by a filter as the oil is

Roman, I just wore out my original wheel and have been unsuccessful trying to find a replacement here in the states. Please place me on your list for 3 Wheels. Either M80 or M60 is ok for me. Your

Great! Thanks again Looking forward!

Hello all ,guys I have the opportunity to buy original size ,grinding wheels from the renowned company TYROLIT 65x6x16 mm ( grid M80, M60 depends on what we want, but only one type of grid for all

As far as I remember, 4 speed mill takes no oil anywhere. For sliding surfaces like leadscrew and column you can use any oil, but way oil (usually ISO 68 thickness) should cling well and make as

Thanks for the reply Vedran. I will re-check properly when I will remove the grease and clean the gear box. At the first inspection, everything looked intact and the gears moved freely. Thanks for the

If nothing is broken, the most logical explanation is that someone was in there before you and managed to drop the brass block in the process. It's pretty much impossible to remove the thing by

Hello everybody, I am new to the group. I just got Maximat V10 milling column attached to a very heavy metal base connected to Sweden made xy table. So no lathe. I have a no much experience in metal

Hi Anton This is the wiring diagram you will find in the manual Check that your lathe corresponds The switches are viewed from the top and “folded out” pictorially from the centre line The three

Hello, Carvel. Thank you for your help. I don't understand electrics well, but will try to figure it out. Regards, Anton.

Hi Anton Welcome to the group The Δ/YY symbol denotes a 3 phase Dahlander connected motor You need a 3 phase supply and the switch bank on the lathe must be for the 3 phase system It should work well

Hello. I bought an Emcomat 7 with a Δ/YY 220V, motor supplied by someone earlier. The previous owner tried to connect the lathe with a VFD, but the motor does not work correctly (no second speed).

Hi Jay Difficulty in running up to speed can sometimes be due to oil which is too thick Check you have the right grade of oil in the gearbox If a starting booster cap is necessary your simplest option

I've been running the machine on those capacitors for a month or so now, and it's been performing well. Both motors seem to be perfectly happy without the starter cap, other than the spindle in

I purchased a 6-jaw Sanou chuck and I disassembled it for cleaning. It was clean inside and lubricated. I squirted some extra oil here and there to justify my opening it and that was that. Of course,

Hi Ricky, IF you decide to go for the Sanou, be prepared to strip it down completely as soom as you receive it and do some cleaning up and deburring (mine had bits of swarf falling out of it and the

Hi Jerry Thanks for filling in the gaps ? Regards, Carvel Sent: Friday, May 2, 2025 1:55 AM To: [email protected] Subject: Re: [emcoV10lathe] Spindle size and thread alien to manual Hi Carvel,