Hi R about torque is possibile somebody take out motor and he dont put back key in to keyway this key has small lock pin ,so take out motor and be sure this key is there ,other issue can be some of your tufnol gear has no teeth or gear on quill spindel has no key, so you have to open mill lid with motor and check up it inside ,long time a go i had similar problem just key was gone :)?good luck Roman
I¡¯m new here and new to vintage Emco machines too :)
?
my background is marine engineering and I have questions about my new machine that more experienced ppl will likely know !
?
First issue and the main one is the mill motor spins over but has no torque, you can stop the spindle by hand even in low gear ¡¡
?
the motor wiring looks suspect to me v¡¯s the wiring diagram?
?
at some point the 4core cable has been replaced and the coulors do not match which is a pain !
?
first wire issues are two of the motor wires were joined together not per drawing, Earth ok
?
so I would need a technique to I¡¯d the wires at the motor end and replace the cable for the correct coulor code
?
next question : Is there a controller for the motor or just a simple switch ?
?
next question : Is there a manual for the mill only ? I have the standard manual with some details but not what I would consider a full manual / leads onto ¡..
?
how to adjust the spindle bearings if at all possible?
?
I think that covers the main points if any folk can help !
