--- In emcoV10lathe@..., "Barrie Lever" <lancia038@...> wrote:
I am also looking for the same type of quick change tool post setup
I have looked at the following companies offerings
I also keep a close eye on Ebay for original EMCO Q/C toolposts but
they usually go for high money.
Sometimes I even think of going mad and going for a new EMCO toolpost,
I will dig out the price and post it here on the forum.
Regards Barrie
I thought that some of the emcos came with Dickson (sp??)
toolpost. Which I think were made in England. At least this
was what I had been told by some guy at Blue Ridge Machinery.
Being in the UK, do you have easier access to Emco
products? Are they easier to get parts for in Europe?
On my machine previous owner attached a massive Aloris AXA toolpost
bolt (1/2" bolt I think). It is not clear how they attached
it. It looks like some part is pressed in, drilled
and tapped. So I don't think that I could easily go back.
Or at least I would be scared to screw it up.
I stumbled across a post on some old group that indicated that
the Super11 had the same problem at least with the cut off tool.
-Almus
