开云体育

very reliable info well known amp builder evert Verstuurd vanaf mijn iPhone

Can you check the location that you're trying to load from using Windows Explorer (file manager), maybe by trying to rename a file to see if you have write access to the file. PSUD under Windows can

Attached DHTRob manual/guide, could I trust him? or do you have a better tutorial/guide to use PDUII? TIA Felipe

Win 10,? kept current.? Build 76. Thanks, Jack

Would need to know about your setup: Type of operating system (MacOS / Windows), version/build of PSUD from Help|About. Regards, Duncan

I haven't used this for a while and now find that I cannot open any of my saved .psu files.? Looks like some permissions issue.? Any suggestions? Thanks, 73 Jack KZ5A

Hello Duncan, Thanks again, attached requested rectifiers.txt file. Kind rgds Felipe ________________________________ De: [email protected] <[email protected]> en nombre de Duncan

Hi Felipe, This is the old version so the previous advice will not help you. Could you please email your rectifiers.txt file to me at postmaster@... and I will take a look at it for you,

Hi Duncan, Thanks for support, attached screenshot. Best regards Felipe ________________________________ De: [email protected] <[email protected]> en nombre de Duncan Munro

Hi Felipe, It may be you are using the more modern version of PSUD II which doesn't use rectifiers.txt? If you go to Help -> About it will tell you the version number. If it's build 74 (version

I added some rectifiers to rectifiers.txt, but when open PSUDII aren't available? TIA for help Felipe

Hi Chris, I had this issue a while back, it's security related. Please check Message #20 ( /g/duncanampspsud/message/20 ) within this group for some suggestions that may

Good morning. ?Running MacOS 12.1 Monterey. ? When I opened psud this morning, I got the following error popups. Clicked "OK" in both cases to ignore, but psud does not open. Downloaded build 77,

Hi Duncan, The small resistances are the wire. The circuit is as built in the amp. I know I can parallel up the parts and had done so in the initial run. effective saves

Hi Ian, This circuit is problematic in a significant number of places. R1 - 10 milliohm resistor goes into 40uF capacitor with series resistance of 4.24 ohms and an inductor with resistance of 25

On 12/12/2021 09:40, Paul Reid wrote: On 12/12/2021 12:14 PM, Ian Eales wrote: I get OOM messages when I try to simulate over 80s delay. Seems

Sorry; attachment fell off. Showing 7 sec for 99 sec.

For what circuit?? Using default circuits, even with extreme capacitor, on an older 8GB 3MHz Win7 PC, 99 Second simulation: no error and 7 or 8 seconds. Also: what do you expect to change at 80

Hi Duncan, My PC has 32GB and I get OOM messages when I try to simulate over 80s delay. Additionally, is updating the screen with calculation status slowing the final

Hi Fabio, This is on the "to do" list, there have been a number of requests for this type of hybrid bridge rectifier where users want a vacuum tube top half and solid state bottom half. Spookily,