开云体育

Greg, I’m very aware of Gapgte. But that’s not it. It seems to be world wide feed when it happens Arnold

Hi Arnold, Check to see if it's coming from "GAPGTE". As I understand it, that station is basically forwarding some not-insignificant portion of the APRS-IS through RF to a cabin up in the Sierras

I'll watch and see what server(s) if/when it happens again. Arnold, KQ6DI

Hey Arnold, I can appreciate your situation here and while I can recommend some ideas, the real issue seems to be coming from the remote APRS-IS server. If you know the traffic was coming from a

Unfortunately I didn't capture what was being sent. I should have done a screen shot, but didn't. The three cases I've seen were on slower, MORE EXPENSIVE, internet connections, and my first reaction

Remember the IGate design is such that the upstream APRS-IS server forwards packets that the IGate MIGHT be interested in transmitting on RF.? Unfortunately, some IGate implementations (I cannot

By the time you looked, I had removed the filtering and the IGTXVIA 0 has been commented out. When I looked at the Screen for direwolf, it was constantly scrolling with stuff for the IGate to

Hey Arnold, Looking at this T2ONATARIO server by going to http://status.aprs2.net/ then doing a search for "T2ONTARIO", clicking on that to take you to http://72.38.114.30:14501/ . At the top of this

I'm seeing odd behavior on a couple of IGates. Occasionally in the last couple days they are being sent thousands of packets to be "transmitted" as if they are suddenly receiving a full APRS feed. For

Fixed, Thanks for the clues. I switched off the pre amp in my radio and that seemed to fix it. I am new and learning. I was using SSB earlier and trying the different functions. Jeff Sent: Thursday,

Hi David, Thanks for the attention. I am pretty much using the default configuration files for direwolf. In that, the line for FIX_BITS is commented out. As far as the radio interface, I am directly

+1 for the comment about audio bandwidth. To me, the signal sounded "funny" when played in Audacity, and John's comment about audio bandwidth - I'd call it audio "strangling" - took me back to the

Let's take a look at it with Audacity. This is what it should look like. (test1.wav) The spectrum should be similar to this. Most of the energy in roughly the 1200 - 2200 Hz range. This is what you

Hello Jeff, What is your direwolf configuration in terms of your demodulator settings, FIX_BITS, etc? As you can see below, the top file is the test1 file and the bottom one is the jem1 file. Few

Hi, I have been tracking down a problem with direwolf and have narrowed it down to the sound input file.? I saw this problem on both a raspberri pi and a pc. I have tested both version 1.7 and 1.6

All things seem to be working elsewhere. I can key the radio through the Bluetooth with PAT to make a 10 meter connection. I had direwolf working with Xastir through a CAT cable but I do not have the

Setting up bluetooth serial ports on a Raspberry Pi is possible but takes some work (maybe some 25 steps or so). I assume you have the Linux rfcomm interface fully working on one side (paired,

Hello, I just replaced my CAT cable from my pi to my Yaesu 857 with Bluetooth CAT control. I can not figure out what the correct syntax is in direwolf for PTT. Everything else with the Bluetooth CAT

Hello Herber, If running this script from the command line WORKS but from cron does not, this isn't a make/model issue of your particular SDR. Something else is wrong. It should be mentioned that

John Did try this option and had a whole different problems, I am going to blame it probably in the SDR type I am using. Waiting for another brand I order to see if this could be resolved. Gracias