开云体育

I've attached a screenshot of the DireWolf -dgt startup. MY APRS Rig is fully outdoors. I don't see a reply from a digipeater in response to my outgoing packet(s). I am using Raspberry Pi 64-bit OS

I've attached a screen shot the Dire Wolf -dgt startup. Thanks again for the assistance. ________________________________ Sent: Saturday, October 12, 2024 5:56 PM To: [email protected]

What is shown on the screen?

Just correcting a few mis-statements in the following.?? Nothing to help the original poster, but to keep the record straight for other readers. This is the APRS format of coordinates which is

Hello Doug, I looked at your .docx file but it doesn't show the output of direwolf starting up. Can you please add that? Hmmm.. bummer. SD cards can die if you don't use good quality cards AND tune

Hello! New to the group, thanks for allowing me to post. I've been running APRS/Dire Wolf mobile tracker successfully since 2020 with the same physical setup. My SD became corrupt and like a dummy,

If it mysteriously stopped working then mysteriously started working again and you did not change anything, then the problem is probably external. Direwolf has loads of debugging features to reveal

It started working again this morning. I can't help wondering if somebody somewhere saw my post and fixed something?

I have a digipeater and igate that's been running for several months. Sometime within the past two weeks it stopped sending received beacons to APRS-IS. It's logging in to asia.aprs2.net and it's

Hi David, I just purchased the latest DigiRig. I have used it many times in the past. It’s a plug and play connection into the DIN6 AND DIN8 inputs in the back of the radio. My laptop recognizes the

Hi Mark, flrig is rig-control software and if that works for you, then clearly you have a working hardware configuration (wiring) between digirig device and radio. Since flrig is very versatile, by

If WSJT-X and Flrig/Fldigi are working, then there is no reason why Direwolf can't be made to work (of course, only one application at a time). How do you have WSJTX / Flrig configured? - PTT - serial

Hi Thomas, Thank you for the very detailed explanation. The digirig is also used for FT8 and WSJT-x and there are no issues with CAT (rig control) or Audio (Decoding) with this radio. I didn't think

Hi Mark, Unless you modified the digirig from its standard configuration (it does have internal solder jumpers), the PTT signal from the digirig is RTS. If the radio starts to transmit (and keeps

Hi Thomas, Since I wrote my post, I was able to configure DIREWOLF so that it will TX upon boot-up.? However, it stays in TX and I have to use CTRL-C to turn it off.? I tried switching from PTT COM5

Hi Mark, You are leaving out the most important aspect, which is what kind of radio you are using and how it is connected to the digirig device! There is no amount of software configuration that will

Good Evening All, I have set up PINPOINT on my laptop and want to use DIREWOLF as my TNC.? I am using the DIGIRIG mobile interface and it is working.? There are no issues receiving packets with

Hello everyone! Sorry for the milking delay in replying. My rules now look like this: rn1m@nanopineo:/etc/udev/rules.d$ cat 50-gpiod.rules SUBSYSTEM=="gpio", KERNEL=="gpiochip*", ACTION=="add",

It seems you're on a Mac which I don't have a lot of experience on. Are you sure the /Users/glloncon/direwolf.conf file is present and the file permissions are set for it to be readable? --David

hola. espero puedan usar un traductor para entenderme: utilicé brew install direwolf y no logro hacer funcionar o que hacer para utilizar direwolf.? al colocar direwol en la terminal me aparece el