开云体育

Hello John, This should work fine. What are you configuring in your direwolf.conf for your serial port device and desired signal? Are you using the common default signal of the "RTS" signal? In

Am building an APRS Digipeater/Tracker for mobile use. Have an EasyDigi with the USB-to-Serial for the PTT. Have tried to use this but as soon as I have configured the serial port the transceiver goes

50/50 chance it had NOTHING to do wit the EasyDigi. Been using homebrew sound card interfaces for over 20 years and never killed a computer.. I did plug a 13 pin Kenwood connector into a Icom once,

Jim, back in 2019 I fried the motherboard of my laptop when I was switching radios TM V-71a to FT-891. At that moment I was using a USB soundcard and all I did was switch USB printer able from radio

Thank you for referring me to the ubuntu instructions. That was helpful and it worked. Have a great day!

Not quite sure what better advice anyone could give beyond what Direwolf already has... "Please fix the device permissions, e.g. by installing the udev rules file rtl-sdr.rules"

you have a permissions issue or something else is using the dongle read down on this page to read up on the udev rules https://www.instructables.com/rtl-sdr-on-Ubuntu/ does the dongle work with other

I believe I have followed the directions to install the sdr version of direwolf.? I run into the following error upon start up using rtl_fm -f 144.39M - | direwolf -c sdr.conf -r 24000 -D 1 - Dire

Direwolf 1.7 Snapshot A works well on Windows with my DRA-65 audio adapter and "PTT CM108" in direwolf.conf. VOX is disabled (by jumper) in the DRA-65.

And v1.7 does work fine with the various DRA models, I have been testing it the past few days. It should also work fine with any of the other C-Media based devices that use the audio chip GPIO pins

John WB2OSZ has released Direwolf 1.7 Snapshot A which includes a Windows binary that includes native CM108/119 PTT support on Windows. Give that a try with your Master Communications device:

And really beating a dead horse now, attached are some audio samples of on-air packets. The first several are with TXD set to 250ms, the last several are set to a ridiculous 900ms. You can easily hear

And when I assemble DRA-65 and 70's, one of the tests I do is jumper for VOX mode, set up for packet operation, and connect to the local RMS gateway. My default TXD is 250ms and they work fine with

Thank you. will look for that

Thank you, Will print that out at look it over -- Rodney D. Myers <WG4USA@...> - wg4usa They that can give up essential liberty to obtain a little temporary safety deserve neither liberty nor

Hello Rodney, Which version of Direwolf? Should be v1.6 Not sure what you mean about "serial cable". You need an "audio" cable to be connected to the RA35 sound device Ok. Following random YouTube

Since there is a message in your startup screen shot that says "... Note: PTT not configured for channel 0. (Ignore this if using VOX). ..." I'd say you are either NOT using VOX, or your VOX is not

My understanding is NOT backward at all.Remember the original post is about VOX, not HARDWARE PTT control.? With VOX, the actual radio PTT line CANNOT be asserted until there is audio for the VOX to

Robert, Your understanding of TXD is backwards. TXD starts when PTT is set. During the TXD time flag characters are sent which gets the receive modem in sync. When TXD ends the data frame is sent. We

The subject and requested information for this thread was Masters Communications VOX. So you agree that using VOX in the DRA-65 or DRA-70 isn't worth talking about and the only thing to talk about on