One problem after another here.
OK, so Direwolf is finally working for the most part.
My SCU-17 has the FSK light stuck on likely because of the RTS signal. When direwolf is run the FSK light comes on, when PTT is keyed it switches from FSK to PTT until TX is over then it switches back.
I have no idea if it's related to my issue, but there it is.
The issue now is when I have that station transmit to any of my other stations, FT3D or my iGate, neither of them understand the signal or rather rarely.
I've seen 1 success receive out of MANY.
Just wondering if anyone has any ideas as to where to look?
I can hear the problem station transmit and hear the modem noise but the other stations don't understand.
I've adjust the Tx volume, no change (turned it down until barely audible then back up a touch)
I've adjusted the TXDelay up to 1000 in 200 increments, was successful once at 600
The radio in question decodes just fine as far as I can tell as I haven't seen a failed decode yet.
Config is...
ACHANNELS 1
ARATE 44100
#ADEVICE plughw:CARD=CODEC,DEV=0 hw:CARD=CODEC,DEV=0
ADEVICE plughw:CARD=CODEC,DEV=0
DWAIT 0
SLOTTIME 10
PERSIST 63
TXDELAY 300
TXTAIL 10
FULLDUP OFF
CHANNEL 0
MYCALL KD7WPQ
MODEM 1200
#PTT COM1 RTS
#PTT COM1 RTS -DTR
#PTT /dev/ttyUSB1 RTS
PTT /dev/serial/by-id/usb-Silicon_Labs_CP2105_Dual_USB_to_UART_Bridge_Controller_00F8CEC3-if01-port0 -DTR RTS
AGWPORT 8000
KISSPORT 8001
