开云体育

Certainly not lab grade but functional and likely very handy. ?I have the FINISRI tablet. ?Most of the use is just to see if there is a signal where rough measurements are fine, with frequencies

Thanks Peter animal

Thanks John , will add Siglent to by search animal

DeOxit products are good for contact cleaning. I have a Rigol scope and it works well. -Pete

Three years ago, I got a "Siglent Technologies SDS1104X-E 100Mhz Digital Oscilloscope 4 channels". I wanted 4 channels, recording depth,, decent sample rate, 100 Mhz bandwidth was good enough for

hey folks , so I'm startin to get a bit more serious bout buying a new oscilloscope . Does anyone have any experience with any of these Hanatak , Rigol , Iwon , FNIRSI or the like ? I'm also lookin at

Sorry about the repeated messages, the PrintScreen looks good on my e-mail screen but continues to appear to be illegible on the loop-back

Retry on PrintScreen Here is another possibility.... Victor Allen, ? VV? Below? VV - At the bottom-? says he might be able to help! ---

Here is another possibility.... Victor Allen, ? VV Below VV?? says he might be able to help---

One more time.... https://www.ebay.com/itm/116020564625 Maybe the seller would make appropriate copies for a little compensation.... GL

Here is one... https://www.ebay.com/p/1227641119 Maybe the seller will photograph, or photocopy, or scan to PDF the manual for a $5 offer? Maybe "Print Screen" the actual eBay images as well... Good

hey folks , wondering if anyone here has one of these small Miller 2000 compressors , Probably sold for air brushes back in their time . I'm looking for a copy of a manual for them . One of mine

Can one use the direct drive motors to position the table accurately? With a stepper I know the position but wonder if on-off gives you precision. Would you use the motors for

??? thanks John . ??? animal

I’ve passed on your email to Donald at Bergerda so he’ll know that you were recommended by me. John Sent: November 4, 2024 5:45 PM To: [email protected] Subject: Re: [digitalhobbyist]

I bought mine from House of Tools here in Victoria before they vanished. It’s equivalent to the Grizzly G3616 which has the smaller table etc. compared to the G3617 which also has the horizontal

??? I need to find pricing for these Bergereda motors .? John I think we may have the same mills ?? I noticed that the lower spindle Collar? on my spindle was loose letting the spindle move up &

I have seen years ago, a Bridgeport clone mill Z axis column power fed with a Nissan? used to be "Datsun 260 "cold weather starter motor. Titon Eng CA produce a Super starter and there original

Sent: November 4, 2024 7:40 AM To: [email protected] Subject: Re: [SouthBendLathe] DIY power feed for mill ? I found this video that shows a power feed using a wiper motor. It allows for

I’m now running Bergerda AX Servo’s on all axis with the exception of the 4th Axis Harmonic drive which has a 3 phase motor but a different Servo Driver. https://www.bergerda.com/ Bergerda does