开云体育

I want to add a 'please wait' page when a stepper happens. Then, flip it to a source page without user interaction. I have 5 sources. Crestron helped me with getting the one source to work using a one shot, but I couldn't get it to.work for the other 4 sources. Any ideas?

Did you already try with a subpage feedback join?

---

?

You must already have something like an interlock being set to track which source page the user should be brought to, correct?

So if the one-shot is causing the "please wait" page to appear, you can take that same signal into the negative-edge trigger of *another* one shot, then take the output of that one-shot and trigger the enable line of a buffer with it.? The other inputs of the buffer would be fed with the outputs of your interlock, and the corresponding outputs of the buffer would be fed to joins on the touch panel symbol matching the joins you have assigned to each device's page.

? - Chip

Yes. I was able to get the first source to work using the subpage feedback join. The subpage is my 'please wait' screen. Do I need to create a subpage for each source?

Ah - I assumed that you already had pages.

Yes - make a sub-page for each source, and eliminate the other one-shot I mentioned.? If you take the inverted output of the one-shot you're using to show the "please wait" and use that to trigger the buffer, then the selected source page will appear as soon as the please wait message goes away.

This also assumes that you're flipping from something like a title page to a second page that hosts the "please wait" and source sub-pages.

? - Chip

?Why don't you have the source selection?initiate?the page flip and use the busy signal from the stepper to drive a "please wait" subpage on top of the displayed page?

Thank you! Because I'm a bit of a beginner, can you tell me the logic I should use? :)