--- In Crestron@..., "Joseph Porter" <ttbtssav@...> wrote:
Anyone have some real world experience with this? I have pins 1 and
9
feeding a relay that has a 24VDC coil. The coil uses 35mA of power.
The IO mode is 0 for Essex. When I close 1 and 9 in programming
nothing happens. When my installer measures voltage on 1 and 9 while
its open he's getting 5.5VDC and when it closes he gets 0 VDC. I
would
think he should be getting 24VDC.
I'm wondering if the constant 24VDC from pin 10 should feed the coil
and land on the switched output, like its sinked?
