its 2 much easy .
-in ya case u must use ethernet intersystem communication not cresnet
intersystem communication cus thier is no cnet in the qm-rmc.
-connect the female-female serial cable 2 the qmrc and asign ip for
the prossesor and add the ip id and the ip of the target prossesor in
the qm-rmc.
-same thing in the the other prossesor.
-enter to the simpl window of the first prossesor , in the configure
view go to the device window , ethernet control module extand it ,
extand the ethernet intersystem,add the ethernet intersystem
communication to the same ipid assigned in the ip table of the
prossesor and edit it , change the ip of the target device,save it.
-open the smpl window of the other pros and do the same thing in the
same ip id but add the ip of the other prossesor save it and upload
ya prog.
-if u r using hub to connect the 2 pross the lan wire must be
straight else it must be cross.
-u can ping to the 2 pross if ya pc is connected to the hub,or u can
use alive command frrom view port.
if u have any clearification...
rabih brahim
+96566129409
marselle001@...
