Anyone has advice on how to shorten the commands?
Example, currently the only way to see it after login (each line is a command):
enable
config t
interface 0/1 (or range)
no poe
Also, to get status, the response is far from ideal as it prints out a table:
(M4250-26G4XF-PoE+)#show poe port conf all
? ? ? ? Admin ? ? ? ? ? Power ? Power Limit ? ?High Power ? ? ? ? Detection ? ? ? Disconnect ? ? ? ? Timer Schedule
Intf ? ?Mode ? Priority Limit ? ? ?Type ? ? ? ? ?Mode ? ? ? ? ? ? ? ?Type ? ? ? ? ? ?Type
? ? ? ? ? ? ? ? ? ? ? ? ?(mW)
------ ------- -------- ------ -------------- ------------- --------------------- ----------- --------------------------------
0/1 ? ?Disable Low ? ? ? N/A ? ?Class Based ? ?Dot3at ? ? ? ?4Pt-Dot3af ? ? ? ? ? DC ? ? ? ? ? None
0/2 ? ?Enable ?Low ? ? ? N/A ? ?Class Based ? ?Dot3at ? ? ? ?4Pt-Dot3af ? ? ? ? ? DC ? ? ? ? ? None
0/3 ? ?Enable ?Low ? ? ? N/A ? ?Class Based ? ?Dot3at ? ? ? ?4Pt-Dot3af ? ? ? ? ? DC ? ? ? ? ? None
0/4 ? ?Enable ?Low ? ? ? N/A ? ?Class Based ? ?Dot3at ? ? ? ?4Pt-Dot3af ? ? ? ? ? DC ? ? ? ? ? None
0/5 ? ?Enable ?Low ? ? ? N/A ? ?Class Based ? ?Dot3at ? ? ? ?4Pt-Dot3af ? ? ? ? ? DC ? ? ? ? ? None
0/6 ? ?Enable ?Low ? ? ? N/A ? ?Class Based ? ?Dot3at ? ? ? ?4Pt-Dot3af ? ? ? ? ? DC ? ? ? ? ? None
?
