So it's going to be a bit different since the 8x2 has 2 outputs,
but for my HD-MD4X1-4K-E, the only signal I have hooked up to the device
in my SIMPL program is the [Video_Out] input that is fed by an Analog
Initialize.? The inputs on the Analog Initialize are fed by steppers
that are used for selecting each computer that I have connected to the inputs.
My HD-MD4X1-4K-E device was acting up recently after I returned from vacation.? It wasn't picking up an IP
address and I also couldn't switch it manually, but after a few cycles
of pulling the power plug out, it has been working fine since.
On Tue, Aug 27, 2024 at 4:43?PM stefuel2 via <stefuel=[email protected]> wrote:
I haven't had any time to play with this switcher for a month. I'm fairly sure there's nothing wrong with the switcher as I can make it switch remotely from DM Tool in toolbox.? Not doing anything fancy.? I just want to see it switch.? I have been looking for a example program including this but came up empty.? My last try is a "or" expanded to four inputs, connected to videoenter on the switcher with the signal name video_enter.
I'm using 2 "analog initialize" expanded to four inputs with the same input names as the "or".? One "init" for each of the 2 outputs.? I'm using inputs 1-4 so 1d-4d.? I have the output of the 2 "init" connected to the inputs videoOut1 and videoOut2 with the signal names "source_for_output_1 and source_for_output_2.? I think this should be switching but it is not.? What am I doing wrong here?
