¿ªÔÆÌåÓýThanks for the update.? Good news on how nice the picture was after things sorted out. Your curved screen would have required as low a profile mount as
possible.? However, I personally don't mind a flat screen that is
mounted away from the wall.? I actually think the "hanging in air"
look is reasonably aesthetically pleasing.? So, In my home I use a
"full motion" TV mount as I find it so much more convenient to be
able to pull the TV out on the hinges of the mount during
installation and later if I have to, for example, change the
wiring of the inputs.? I also use a piece of heavy duty 3/4"
plywood between the mount and the wall so I can screw the plywood
into the studs and then the TV mount can screw into the plywood
wherever the mount has holes for screws.? I was taught to do it
this way in the days of super heavy plasma TVs and the dealer I
worked for at the time never had one fall. Thanks again Jay On 10/15/2023 4:47 AM, stefuel2 via
groups.io wrote:
Well as far as Ex-link goes, in my limited application, the S95C works perfectly with it.? The Sammy I replaced was a previous flag ship curved screen.? I can't remember the model number but even at it's current age, had a stunning picture.? It had 12 zones of back lighting and one dropped out which prompted this.? The curved screen was the second flat screen since I stopped using CRT front projection.? In between nigh end CRT and flat screens I briefly tried digital projectors and absolutely hated them.? OK back to the S95C.? The previous curved screen was on the lowest profile wall mount I could find.? The supplied "one link" interface provided would not fit in between the tv and wall so I was forced to shim the the wall mount plate 3/4".? For that, I used a scrap of PVC trim leftover from the new garage construction.? There is no instructions or anything in the box to do anything but mount this one link to the supplied tv stand so I had to make my own template and figure out where on the wall behind it would be accessible and be fully out of site.? In my case, that was center bottom as close to the wall plate as possible.? There's never any studs in the wall where you need them so using my template, installed four shields and screws to hang it from.? Upon powering it up, I used the supplied remote to go through the setup menus which were super sharp making me think WOW this is awesome.? After going through the setup, was able to see the first actual image sent to it from my Integra.? The source was 1080P from a Dune media player.? It sucked big time.? It looked like bad 720P.? WTF is going on here.? Off to the internet to see what's up.? Perhaps I need to change something in settings.? After 30 minutes of scouring the internet only to find nothing, went back to the tv to try and sort it out my self.? By that time, my autistic son was there.? He changed the movie to something he wanted to watch and it was perfect.? I switched back to what I was watching and now it was perfect.? Perhaps it was still sorting it's self out.? I don't have a answer to that.? Right now it's completely out of the box settings and looks awesome.? I'm not going to attempt to tweak it until it gets some time on it. |