开云体育

?
?

/g/crestron/message/245762?
/g/crestron/files/WakeOnLAN%20Examples%20-%20UDP%20and%20Crestron%20Certified%20Drivers.zip?

I downloaded the QN55LST7TAFXZC driver and inspected the UserAttributes (below) as described in OLH 1000527.
Have you confirmed MACADDR$ (and other required UAs) is being sent into the module properly and WOL magic packet is seen when PWR ON is pulsed?
It may be prudent to confirm network topology & settings aren't blocking broadcast packets.

UA1 = Device Settings = To configure for IP control, use TV remote and press Home button, navigate to Settings > General > Network > Expert Settings, turn on \"Power On with Mobile\" and enable \"IP Remote\" settings. Then follow Enable Instructions
UA2 = Device Settings = To enable IP control, begin with TV powered on, then while driver is being loaded, look at TV for message to allow IP Remote control, use TV remote to select Allow, for control
UA3 = String Input Required Before Connection =?Mac Address of Samsung IP Device.?This is required to turn the Display on. Please provide in the format of AA:BB:CC:DD:EE:FF.
UA4 = WOL Notice =?Since this device uses Wake On LAN to power it on, the driver can have an extended warmup time where control may not be available for several tens of seconds. Please note this for this driver.
UA5 = String Input Required Before Connection =?DefaultDigitalCableChannel =?The digital cable channel displayed when selecting the digital cable source for the first time.?This is required to be able to set the channel when a cable service is being used as the TV source for digital channels.
UA6 = String Input Required Before Connection?=?DefaultAnalogCableChannel =?The analog cable channel displayed when selecting the analog cable source for the first time.?This is required to be able to set the channel when a cable service is being used as the TV source for analog channels
UA7 = String Input Required Before Connection?=?DefaultDigitalAntennaChannel =?The digital antenna channel displayed when selecting the digital antenna source for the first time.?This is required to be able to set the channel when an over the air antenna is being used as the TV source for digital channels.
UA8 = String Input Required Before Connection?=?DefaultAnalogAntennaChannel =?The analog antenna channel displayed when selecting the analog antenna source for the first time.?This is required to be able to set the channel when an over the air antenna is being used as the TV source for analog channels.