Create an AINCF for each mode you want, most cases Heat and Cool (Auto as well if using Single Setpoint, best to just skip whatever junk logic is in that module).? Set the increment to 10, lower and upper limits to whatever you want you want, I think I just use 400 and 900 for both, have yet to see it be an issue, but that could change (degree * 10 for analog).? Up/Down will be that modes setpoint+/-, fbcksignal and aout tie to that mode on the 1.0 module.? Buffer a generic setpoint +/- to the appropriate analog increment based on the 1.0 mode feedback.
This is all assuming F not C.? Change the maths if thats the case.? And yeah, don't rely on CurrentSetpoint in the module at all, buffer the analogs and use Analog to Serial if need be.
--
Ryan Baldwin
CEO | XS Design Studios
rbaldwin@...
760.712.2240
