I have two CP2Es in my system with one being a master and the other being a slave.? I just upgraded my cable modem and a side effect is that my home router went from the 192.168.1 IP range to 10.0.0.? Basically this means I need to reset the IP addresses in my Crestron system.? I connected to my main CP2E via RS-232 to change the IP address without issue however with the slave one when I try to connect it cycles through the different Baud rates and then fails to connect (no device found).
Anybody know why the slave CP2E won't connect?? I went through this about a year ago and didn't have an issue connecting to the slave CP2E via RS-232.? Thank you.
