On Wed, Nov 25, 2020 at 11:00 PM, Oil Country wrote:
<snip>
" Just to recap press a command on ML600 and look at Emitter with iPhone
camera in selfie mode ?select FaceTime and see if it flashes? "
That's correct, but I was a little unclear. You don't have to open the FaceTime app itself. I was calling the button to turn on selfie mode the "facetime button" :)
I was curious I can test each port for example E,F,G,H separated with a two
plug Phoenix connector they don't have to be all plugged in at the same time
with 8 pin Phoenix connector, I assume every signal port is independent of
each other ??
Yes, the spacing between pins allows for each discrete connector to be inserted side by side without interference. Each port is independent. If you remove these connectors often, it's good to have a puller -- basically, a pair of tweezers with the tips bent over. Tip: pull from the front of the connector where it meets the machine. If the puller slips, you can pull the back of the phoenix connector off. This doesn't destroy the connector but you've just pulled the back off :)
Wayne
