Like Steve said, just reboot.? If you actually wanted to restart a program, though, it would be "progreset -p:1" for the program in slot 1.
On Sun, Jun 21, 2020 at 11:27 AM Steve Kuehn <
steve@...> wrote:
I usually use "reboot" instead.? I am not even sure if "progreset"
will cause the slave mode to take effect.
At least on my MC3 and MC2E, I don't need to supply any parameters
with "progreset".?? I think you? only need to supply the parameters
when you have multiple programs running.
On 6/21/20 2:37 AM, Sharan Suvarna via
wrote:
Hi guys.
After adding the slave IP table in the console the control
processor its asking me to "Restart program to take effect" , So
I thought of using the "progreset" command. But I am not able
figure out all the parameters in that command.?
?PROGRESET {-P:ALL | -P:Specific Program Identifier} {-V} {-D}
? -P:? Reset a specific
program or ALL.? If not present, ALL assumed..
? -V:? Verbose reset.
? -D:? Don't keep
DBGSIGNAL information (PROGRESET normally preserves DBGSIGNAL
flags).
Could anyone help me out what does those parameters means ? What
does the "-V" & "-D" means ?
Is there any other easier? command that would achieve this ?
Thank You.
