?How i assign a ID to the device? i need some lutron software??
the label in the back of the dimmer says:
Contains:
FCC ID: JPZ0065
IC: 2851A-JPZ0065
CFT: RCPLUGR09-0952
any of this are the device serial numer?
---In Crestron@..., <robertparkernc@...> wrote:
I just used that yesterday. Just to be clear it's "#INTEGRATIONID, 3"?followed?by a?carriage?return "0D" and a line feed "0A"
Do you have this manual?
Just to be clear the?INTEGRATIONID listed in the commands is a name you assign to the device. It can be anything from a single number like"1" to a?helpful?name like"Dining Room" Either way it has to be assigned or you have to use the device's serial number.
On Thu, Nov 14, 2013 at 2:36 PM,
<moskmanz@...> wrote:
?
?i try your string #INTEGRATIONID, 3\x0d\x0a? and dont get any answer.
The RX led in the unit flash when i send the command, the cable is allright.
---In
crestron@..., <robertparkernc@...> wrote:
I just went through this. It will not give you any answer unless it receives a proper command. You got a boot message so your comms are good. All commands need to have a CR and a LF. I would connect directly to it and send this command.?#INTEGRATIONID, 3\x0d\x0a
This will list out all attached devices and their integration IDs. These may not have been set and the response will tell you this. To find out which device was the Graphiceye I wanted to control I turned on button monitoring and pressed buttons on the grapjiceye.
On Thu, Nov 14, 2013 at 2:04 PM, Steve Kaudle
<skaudle@...> wrote:
?
Try a new-line for the delimiter not a carriage return.
On Thursday, November 14, 2013, wrote:
?
its my first time with Lutron, i have:
QSE-CI-NWK-E
in the left i see a serial: 0031-0B0D??? i assume that this is the ID i need for the QS module.
This RS232 control is linked with a GrafikEye QS QSGRJ-6P-1WH
When connect the power to the QSE i get the follow information:
BOOT v2.09 SN: 6027 built jun 04 at 15:07:36\x0D\x0D\x0A
BOOT STARTING OS, START=0x00020000, LEN=0x00037F00, SUM=0x011DAD9A, CHK=0x11DAD9A\x0D\x0D\x0A
then i send a string for example, #DEVICE, 0x00310BD0,36,3\x0D
and then i not get a answer, i dont now if the QSE receive the command or not,
the dimmer is needed to setup and ID? how the QSE identifies every dimmer than
add to the lutron network?
please help :(
