开云体育

Good morning all, I believe a similar thing happened to me, but I have a question that may or may not have been covered. Will any club car 10 tooth spline motor fit a 1980? I want to

The verdict is that my armature is shorted to the shaft... not sure where yet, nothing obvious, but every bar measures continuity to the shaft. [email protected]> wrote:

Yanked my motor. Now my garage stinks like gear dope. [email protected]> wrote:

Thanks!

Stupidly I did this once before but only drove 3 or 4 miles. That was 6k ago. Not accelerated wear from that I found. Will keep you guys posted. I drive 3 to 4k a year now. I am not sure if there are

My d&d was series and I believe 5hp. I put the alltrax 750 if my memory serves me right on it. Noticable more power than stock. Driven it about 8k miles no problems yet.? Sent from my MetroPCS 4G

Hopefully no damage done! If there's a problem it will show itself. Keep a close eye on your fluid and magnet for a while to make sure it's not disintegrating behind your back.

Did you guys choose a d&d that was of similar specs as your old ones? Did you stay series or go sepex? I'm tempted with he thought of tossing my f/r contacts with sepex, but I'd have to buy a new

As title says it was filled to the wrong plug hole. Turns out this whole is a drain plug for if the axle was mounted differently. I made a new set up to test if it was ran dry. At the amount that was

Go with a D&D 6 HP. ?That’s. What I used

I have a d&d motor and love it. I had then add in the ability to make it forced air cooled. I can run the car 35 miles without stop and the motor temp gets only to about 160f. I can look up the part

Well, I killed my motor. It was spectacular.? Somehow its grounded so when power went through it it turned my speedo cable into a speedo rod. It was surprising and smokey, and did not blow a fuse!?

You'll be fine splicing another cable for the power. Use 14 gauge or larger for the ac side. That DC side plug may have 3 wires if it has a temp sensor or a power sensor lead. [email protected]>

charger arrived Its a Delta qui q setup for Ez Go golf cart and missing the power cord adapter it is 48 volt charger though...... maybe splice in a regular plug for 110 and maybe cut the square ez go

Wiring it is as simple as neg and pos, with the caveat that if you have the original series parallel contactor, care needs to be taken to ensure it doesn't end up in parallel while charging, or else

Bought Delta q charger used off craigslist including shipping $150. Charger suppose to arrive Saturday looked to be great condition. Six eight volt batteries all charged individually 12 volt charger

Not sure if any need for one the thought crossed my mind seen this on a search for club car golf https://golfcartpartsdirect.com/Category/439

the cost overrides the hassle with faded vinyl windows the inability to even see out and safety aspect the ability to just roll down a glass window ....

my perfect thought of a glass window setup advice, a wet polishing cloth, and a plastic cream polish i will post the pictures once i have my glass framed windows made and

I think that I'll be taking my windows to a boat shop and have them refurbished - no idea of cost Bart