开云体育

I have tryed this config without success, no answer when pinging 192.168.0.114 from the client. Probably missed a lot.... *Client bpq* node SG0YOS without internet connection *Server bpq* node SE0YOS

Disable the service and run linbpq manually. Then you will see any error messages. 73, John

Ok, Thanks. I'll be away for a few days but will look at it what I get back. 73, John

I am configuring linbpq on a Pi Zero W, when it was installed the default config BPQ was running so I started to configure it. After the reboot in didn't have BPQ available? and I am seeing the

PS... I completely forgot that when using QTT in tabbed mode while connected with a bpq node via an FBB port the RF ports do not appear as an option for monitoring until AFTER the initial monitor tab

And so a pair of NPR modems (with TRX built in!!) on UHf should work. https://elekitsorparts.com/product/npr-70-modem-by-f4hdk-new-packet-radio-over-70cm-band-amateur-radio-packet-radio/ I built

Back at it... the attached zip includes the following files. 70cm-between-bridge-and-wlh7.txt - using linbpq status command to demonstrate good packet timing between the linbpq bridge system 70cm

On 3/4/25 10:01, Chuck Gelm wrote: 3s, Chuck

For me no, we don’t have clear line of sight to our repeater site, so in needs to be uhf or vhf. Bob -- Bob va3rjs

Or a pair of NPR modems at ~500kbps assuming you're NOT in the USA where we are crippled at just 56k. [email protected]> wrote:

"over a 9600 baud link. Thomas and Bob: Is 802.11n,ac possible? Near line of sight? Legal in your country? ? 2 commercial outdoor rated 802.11n,ac router-radio-antenna devices would likely be much

Following i need to do the same thing! Thanks Bob

Yes, that should work. 73, John

I plan to run tcpip between two linbpq nodes over a 9600 baud link. I want to access the internet from the node that does not have internet, only radio connection Is it possible? 73 Thomas

No, you don't need amprnet. How are you planning to use it? 73, John

It sounds like aprnet is not required for your application. The thread below may be helpful. /g/bpq32/topic/109357376#msg42447 73, Lee K5DAT <thomasbostrom1@...>

Do I need Amprnet or can i user public internet? 73 Thomas

All set.... Let me know if you see any issues... Have a good evening!! 73 Jerry

Whereabouts in the file is it? It needs to go in a port config. If that's not the problem send me your config and I'll have a look. 73, John

Ok I am sidetracked helping a friend recover a win10 system so will get back to this in a day or two. Thanks John.