PS... I completely forgot that when using QTT in tabbed mode while connected with a bpq node via an FBB port the RF ports do not appear as an option for monitoring until AFTER the initial monitor tab connect... so if it helps the attached zip is take2 showing both RF ports monitored simultaneously within the same monitor tab.
toggle quoted message
Show quoted text
On 3/4/25 11:33, Rich Sahlender via groups.io wrote:
Back at it... the attached zip includes the following files.
70cm-between-bridge-and-wlh7.txt - using linbpq status command to demonstrate good packet timing between the linbpq bridge system 70cm port and my primary home QTH node. Note that since my previous post I loaned the Signalink I was using on the bridge system 70cm port and had to replace with an old h/w pre-MFJ TNCX but the timing still looks good. Note also FWIW that the -7 node uses a KPC3+ on its 70cm port.
10m-between-client-and-bridge.txt - using linbpq status command to demonstrate good packet timing between the 10m client QTT and QTSM with an IC705 and the -13 linbpq bridge system using QTSM and a FT817.
10m-qtsm-bridged-to-wlh7.txt - the 10m client QTSM view of a linbpq status while bridged to my home node.
bridgenode-10m-listen.txt - a bpq listen view of the bridge nodes 10m port while bridge is active.
bridgenode-70cm-listen.txt - a bpq listen view of the bridge nodes 70cm port while bridge is active.
Let me know what else might help if needed.
Tnx es 73 de Rich WA3WLH
