开云体育

Assuming that the address of the LinBPQ machine is 192.168.1.101 this is how it should work. LinBPQ IP Gateway communicates with machines on the same LAN, including the LinBPQ host, using NAT.? On my

These are probably link validation polls which are part of the ax.25 protocol and are controlled by the T3 setting in bpq32.cfg. Although the interval could be extended a bit from the normal setting

Thanks, Sorry about this. It is a bug introduced to the Level 2 (KISS) driver when I added the port specific CTEXT. I've uploaded new versions of bpq32 and linbpq to my beta site. 73, John

I am confused with how to use the ipgateway. 192.168.1.102 is a ip-address that does not exist in my network, it is in a DMZ. The AXIP map statement to my partner node look like this. MAP PI1BDG

Hi Rick, RF ports using which driver, KISS or UZ7HO driver etc? -Red

I have found that 6.0.21.20 is good, so it appears to have started at version 6.0.21.21, John. 73 - Rick KE0GB

Thank you, I just tested my RMS and found the same problem, I have reverted to 6.021.13 for the time being

http://www.cantab.net/users/john.wiseman/Documents/BPQCFGFile.html If your cfg starts with SIMPLE, then the following are set to defaults: BBS = 1 BTINTERVAL = 60 BUFFERS = 999 C_IS_CHAT = 1 FULLCTEXT

Conducting tests with others in the area, I've found that 6.0.21.21 is also bad. 73 - RH

John and Mike: It appears that a bug has crept into 6.0.21.23, giving me the results that I opened this thread with.? The following versions were tested and found to be working as intended: 6.0.21:

I reverted back to version 6.0.21.1 and found that it operates fine.? So, I'm going to check other past versions that I have kept and report my results. 73 - Rick KE0GB

I noticed a strange happening on my system.? If someone connects to any of my RF ports: 2m, HF, or 70cm 9600 bd, using my BBS call, CHAT call, or RMS call and any of their aliases, they always get

RE: " Looks ok to me." Sorry John...missed that..lol Trip - KT4WO

John: Yes, I understand the circuit theory, thanks.? Now that I know where the problem lies, I can make changes, so I have changed the following and will observe: OBSINIT=6 OBSMIN=4 NODESINTERVAL=20

I should add , calling out on the pactor port works fine. Ray

My neighbors are getting a little grouchy that my LinBPQ is polling every 5min.? How do I change this behavior?? Maybe at startup, and once per hour is better. Thanks, Chris KQ6UP

When stations arw calling me , my pactor scs 7800 dragon will not answer, pactor is plugged in rear port of ic 7300 Running latest windows , bpq32 . Running vara , ardop and pactor with ic 7300 Below

Returned to Node COSCO:KE0GB-7 :>c 4 !kb9soz-1 s COSCO:KE0GB-7} Sorry - System Tables Full An rf link attempt just sent me this back rick .. 73..?? --steve,kb9pvh--

Niels: Thanks for the info!? Truly appreciated. 73 - Rick KE0GB

I've done some testing and it's on the MAXCIRCUITS = 128; Max L4 circuits if I lower this I get the message LAPNOD:PI1LAP} Sorry - System Tables Full. Connected to TelnetServer c 3 pi1bdg