开云体育

This is my config to send APRS beacons via VARA HF, the PTT in VARA is done via CAT from BPQ: ;--------------------------------------- ?HF 14.103 / 10.1482 PACKET PORT

If the incoming connect is to the bbs call instead of the rms call the messages will go to the bbs. So long as the forwarding script for RMS tries the Internet first then a packet station it should

Ok, Lee. I think it would be a good idea to delay a bit and to randomize the time so it is less likely to connect to several simultaneously. I'll look into it. 73, John

Digipeater is NP4JN-11 FTM-400 is NP4JN-9 FT3D is NP4JN-7

Hello Jean, I don't know about VARA FM because I've never used it, but the only way I can think of on VARA HF is to set up a KISS over TCP port in BPQ that points to the VARA KISS port. Then others

Hi, There is a way to send a Beacon in VARA? and VARA HF using BPQ? -- 73 de Jean, VA2OM / VE2PKT

This causes me to question the calls used in each aprs device.? They obviously cannot be duplicated in any device, including BPQ. Nodecall and the application line calls might also affect this. Do

Mark thanks for the input. On this: I hesitate to even get into this but if this were mine I would try the following... Port 2 & 4 comment out these

John, G8BPQ We have been developing a VARA HF forwarding network here in the states, we are allowing portable hf station access to packet node & bbs, Winlink RMS & APRS sms & email services. More

Lee, I have made a few changes here to deal with the VARA HF problem you describing. I have adjusted my forwarding script and added a PAUSE line between the first attempt and the 2nd, then the script

Some good information here. Thanks to all.

Mark, You did it! Thank you. That did the trick. In short, there are no duplicate calls in the BPQ configuration. Some of this syntax looked like magic. My actual BPQ node (not the test station) is

I hesitate to even get into this but if this were mine I would try the following... Port 2 & 4 comment out these lines: UNPROTO=APBPQ1,WIDE1-1,WIDE2-1 BCALL=NP4JN-11 The path and bcall used is

I'm a new user of BPQ32 and apps on Win10. I've probably done something wrong but I find that sometimes when I minimize BPQ32 and apps to the system tray that I will lose the menu you get when you

I'm now wondering if having the same value for NODEALIAS and BBS ALIAS is confusing things. But, that is in your original config. If it is still like that you should have different values for

Kayne, Thanks for the pointers. I confirmed that I can establish a successful outbound VARA HF connection via the ATT and C commands. It seems that the problem is just with inbound connections into

Hello I run BPQ32 APRS in various ports, port 2 is APRS and BBS 145.090 in the same channel, port 4 is APRS 144.390, port HF VARA HF etc. I have noticed that in VHF port 2 & 4 not all packets are

Lee, Thank you for providing this level of detail. I am successfully able to connect out to a Winlink RMS gateway from BPQ. So, at least I know that the modem works. ***

One can also use an AGW client like easyterm with bpq's AGW emulator/server. From there you can connect to node 'SWITCH' and issue the C or ATT commands as needed. Latency I am not sure, but VARA

Hello Gaston, * I am able to connect using VARA HF to multiple Winlink RMS stations using Pat from both the BBS station as well as from my other client station that I have been using to access