开云体育

Hi all, I have WinRPR running on my linBPQ Linux machine, but just can't get it to engage transmit.? It shows it's transmitting in the waterfall, but the radio won't actually transmit.?? VARA HF

Hello Could someone point me to the right display control codes for triggering and displaying in the teletext window.? The closest thing I can find so far are the prestel control codes and I have

When setting up the timing for mail forwarding/ reverse, what is the max value that can be entered into the fields for these settings (seconds). BTW minutes seem to me as a better value rather than

Thank you for your response but I need a bit more help, when you get time.? My station was setup by another Ham to be used for a DNTS station receiving traffic from the Region 12 hub.? As such, he

On Wed, Mar 5, 2025 at 11:22 PM, Thomas Bostr?m (SM0YOS) wrote: Is there any way to specify > > sudo ip route add 192.168.5.1 dev LinBPQTAB? ? ? ? ?(on se0yos) in the IPGATEWAY config with

Mark Thanks will review that

Now that I see what you are doing I can honestly say that I found it easier to run RMS Relay in Local Post Office mode together with BPQ to do what you are doing.? (Sorry John!) If you are a gateway

Mark Ok I went back and in fact found that some users did not have the ‘Don’t add winlink.org’ checked once that was done . it worked perfectly Thanks Rob

Mark Wont winlink express add winlink.org if you dont specify a destination ie mycall@bbs I found that if I dont specify and leave it without, it will do callsign@... trying to get around

In your other message stream you asked for posting a bulletin.? Winlink Express will not post as a bulletin.? It is a personal mail client. If you are strill trying that... -- 73, Mark,

Are all the user records for them marked as "Don't add winlink.org" -- 73, Mark, N5MDT Montgomery, Texas http://n5mdt.ham-radio-op.net:52852

now i need a way to remove the @winlink.org since what needed was a way to post from winlink to boqmail as if the the message was sourced on the bbs but it seems it is getting tougher didnt want to

Thank you John

In Telnet Server config set RELAYAPPL=BBS This will cause BPQ to listen on port 8772 and pass connections to the BBS. 73, John

You can specify a Disconnect Script for a port. If you need more than one command seperate them with | DisconnectScript=RADIO 5 14.103 USB It goes in the CONFIG section of a PORT config. 73, John

I am trying to work out a way to send from ?winlink express to bpqmail thru telnet on the localhost I need to generate outgoing messages to a group and winlink express seems to handle this the best

Correct they are on vara in a closed HF environment using winlink express to connect to bpqmail I tested and can originate from a group list from Winink and post to the bbs but I was hoping I can do

Hi, Robert: Put semi-colons between addressees in the address field. e.g. SB or SP

I manually pickup messages from an area DTN hub using BPQMail and would like to go back to a set frequency after forwarding so they can find me when sending traffic to me.? I saw a reference to the

Just to clarify, you want to send a message to a group of people that are NOT on the packet network, correct? 73, Eric WG3K FM18rp Packet: WG3K@WG3K.#SMD.MD.USA.NOAM E-Mail: wg3k@...