开云体育

Aye, It is not explicitly put in the various modem drivers. I have found it by some trial and error. But it IS listed in the uz7ho driver:

I don’t see Frequency and Updatemap in the documentation but i am pretty new to bpq so i may not be looking in the right place…. I will put an “UPDATEMAP” in my config and see what happens.

Mark et alia: Used after PORT ... ?CONFIG ? I have ";FREQUENCY..." 3 times in my bpq32.cfg file. Obviously I have had issue this NAME|VALUE pair. Is this an information line or does it attempt to

I *think* you need the UPDATEMAP in the port config. Tho it may not work for some ports types. I dont have a frequency line here, but have the RADIO section configured for rigcontrol. ``` PORT

Could you send me your bpq32.cfg file so I can see exactly what character's you are using? Thanks, John

ok, but everything is done in 'terminal'. The Config File is written in NANO, the BBS runs in a Terminal, the BBS Output is in Terminal, so everything should be the same I guess. I must confess, I'm

Ok thanks, much appreciated Bob

<christopher.maness@...> wrote: https://www.cantab.net/users/john.wiseman/Downloads/Beta/

Where do I find those executables? Thanks, Chris Maness -Sent from my iPhone [email protected]> wrote:

Probably all it will require is a FREQUENCY line.? Most likely you have anything else you need already. -- 73, Mark, N5MDT Montgomery, Texas http://n5mdt.ham-radio-op.net:52852

Always, always, always install the latest bpq32.dll, BPQMail.exe, and BPQChat.exe all at the same time.?? Ocasionally one will be the same version as the prior but it's better to get in the habit of

Hi my settings in the config file report my node to the bpq map just fine, but i am wondering what i need to do to the config to get it to report that it has an hf port too? -- Bob va3rjs

I installed the latest installer and then installed the latest DLL. My web interface for the mail (BBS) went away. I reinstalled again and I am back to normal, but running the 6.0.24.1 version. I

Pretty sure that refers to pure ASCII vs unicode. Jim KA7EHK

Works fine. I'm not sure that I understand the GPIO terminology or if the GUI needs an update. I was designating the physical pin and it turns out that it is the GPIO Port number (GPIO 25 on pin 22).

@John G8BPQ: Sorry, what do you mean with 'right codeset' please? I copy the ASCII from above right into the bpq32.cfg, for reference the TEXT looks like this. ...snip... CTEXT: Willkommen in der

@Mauro: Good see, but that was my fault. in real World there are 3 Asterisks. BBS is up and running with plane CTEXT without any issues. Thank you 73

Thanks, I'll give it another look. -- Dave Menges

ASCII art should work so long as you have the right codeset, but you can't use \nnn to set control characters. 73, John

Yes, it should. You can select GPIO in the PTT setup. I haven't tried it for a while so would be interested to hear if it still works. 73, John