开云体育

I think I understand what you are trying to do. Even if you are not using tunnels, etc. and only need to run IP over ax25 via a radio, you still need to run the "full fledged" IPGATEWAY feature. You

Hi Mark, its not in the port conf section...Linbpq on a pi4....

Thanks John, I can live with it for now, looking forward to the next version! TNX es 73

At the moment the only solution is to turn on "Don't check from call" in the main bbs config. The next version will include SERVIC as a valid from call. 73, John

Looking for link partners in adjacent states, NE, MO, AR, OK, already have CO and IA. my map, ?MAP KI0BK-7 KI0BK.NO-IP.COM UDP 10093 B I'm located in the Kansas City metro area in KS TNXes 73 jim

Sorry to drag this up again… I’m getting some msgs from SERVIC@... addressed to me KI0BK that are being held so are being delivered in a timely manner to me. ?I could not tell from the

Thanks, Rich. 73, John

Thanks John. I just had a chance to retest with the final .77 and can confirm this is fixed. 73 de Rich WA3WLH

I think I understand what you are trying to do. Even if you are not using tunnels, etc. and only need to run IP over ax25 via a radio, you still need to run the "full fledged" IPGATEWAY feature. You

IPGATEWAY does not go inside of a PORT configuration.? It goes in the main body of the config file. But it could be we are all confused about what you are really trying to do, especially me.? Maybe

Hi, Trying to configure ax.25 tcp on rf port...No tunnels,? no access past Linbpq and rf ports. I have went over and over what John has out as an example but Linbpq crashes when I Enable IPGATEWAY..

https://www.cantab.net/users/john.wiseman/Documents/RigControl.html

Where can I find the documentation of all RIGCONTROL commands? Thanks Heber - NP4JN

TU that was the missing piece! 73

Bleh, I did not format that. Let me try again. :D ``` ATT 3 HFPACKET C CALLSIGN ```

Jim, I *think* for that modem it is similar to this: For a normal (300 Baud HF Packet) call enter: ATT 3 HFPACKET C CALLSIGN If you want to, and have configured, you can send after ATT(aching) the

Can't figure this one out, I want to connect to another station using HF packet ax.25, not robust packet, using my SCS PTC-IIusb. I'm currently scanning for Pactor connects, so I need to halt scanning

Odd, I have that set in housekeeping so not sure if thats working. Say will it look at dates in the RLINES and determine it should be cleaned with housekeeping? KH I've used in a pinch. That works ok,

Housekeeping will remove messages older that the limits you've specified in the housekeeping config. You can also kill all held messages with KH. 73, John

Hi, Every once in a while someone makes a mistake and restores an old bulletin (or some other behavior that gives this appearance) and goes out to the network. Instead of getting them held, is there