开云体育

Hi I only ever run a PK232 with Windows but did find it preferred 9600 bauds as it use to miss commands at 19200 bauds and loss itself. I suggest you double check it is in Kiss, watch for the double

Thank you for your reply Mark . I do believe the port is configured correctly. It just seems to me the program isn’t looking for the TNC. Usually a program with report a port error but absolutely

A look at your port configuration would help.

I have installed BBQ32 on my windows 7 system. I can not get BBQ Terminal to communicate with my PK232 MBX. I must mention that I run several Packet clients successfully? ,with the TNC in KISS mode,

RR - thanks John M -- Thanks. 73 Michael GM5AUG SYSOP GB7AUG, MB7NKL

If you have? SecureTelnet=1 (which is the now the default) in Telnet port config then it should only be available to sysops. 73, John

Oh wow John - what a brilliant idea. So just make sure there's a Telnet server running on the RPi and then connect out on port 2? What a cool idea. Now, is there any way this can be restricted to

Are you looking for access to the Linux shell, or do you actually need IP access? Both are possible, but shell access is much simpler. You just need to connect to the node and then to connect to a

I should add, I'd want to do it on the same port as 'normal' packet? -- Thanks. 73 Michael GM5AUG SYSOP GB7AUG, MB7NKL

Hi everyone Sorry if this is a dim question, but with the IP config spoken about here ( /g/bpq32/message/42440 ) , would I be able to run BPQ as a packet switch but, if necessary,

Hi Jim, Also I have reached out to you via PM here. When you get it or not let me know either way. Happy to accommodate. You can email me at my mail on QRZ, if you have a path to me via packet or I

Jim, I sent you an email to your QRZ address even though I am a state further away than you requested. Did not receive a response.

Heber, The on-line help points to this page. http://www.w1hkj.com/ Also on Windows, the documentation for rigctl and all of the modules of Hamlib are in folder from the downloaded zip file. The folder

Now trying to ping the bbs from a pi5 bookworm 64bit... direwolf /? tncattach with setup for ip with 10.0.0.10/24 and bbs with 10.0.0.1/24. pi desktop pings out rf interface correctly,? no response

that was the last part of the puzzle...thx you for the help and everyone else too.? it's working

sudo setcap "CAP_NET_ADMIN=ep CAP_NET_RAW=ep CAP_NET_BIND_SERVICE=ep" linbpq I think you may be missing the above command from the linbpq documentation. The above assumes you have renamed the pilinbpq

Oh those 4 asterisks LOL, well that made a difference... now to the next issues :) I wiped the pi and started with bookworm 32bit lite....all went well. installed linbpq went well. all is working

When you comment out the IPGATEWAY statement it may render the others unrecognized, thus the error.? Use a multi-line comment when commenting out the IPGATEWAY section: /* IPGATEWAY Adapter eth0

Good day. Here is the full configuration example on the BPQ website. Note there are 4 asterisks at the end to mark where the IPGateway feature ends. There are several BPQ features that use this

OK when I am enable IPGATEWAY linbpq will not run..... heres the config when I remark out the IPGATEWAY ;IPGATEWAY Adapter eth0 44ENCAP 100.64.1.223 IPAddr 10.0.0.1 IPNetmask 255.255.255.0 IPPorts 2