开云体育

Hi, Every once in a while someone makes a mistake and restores an old bulletin (or some other behavior that gives this appearance) and goes out to the network. Instead of getting them held, is there

Sorry, I thought I'd fixed that. I'll look into it. 73, John

Thanks, Rich. Em seg., 28 de out. de 2024, 18:12, Rich Sahlender via groups.io <wa3wlh= [email protected]> escreveu:

A segfault occurs in QtTermTCP on both 32bit and 64bit x86 systems while attempting a K2K session between two instances of QtTermTCP without any node software in between, with QTT configured for the

I'm seeing the same thing when using a Dragon and connecting with Winlink, completely separate from BPQ.? I believe it is a Dragon thing, not a BPQ thing.

I’m seeing this in the log sometimes as well, I’m using a PTC IIusb. Connections to the bbs are normal and working ok as far as I can tell.

Found the missing setting! added setting mycall to the config section of the pactor port. this parameter sets the modem's callsign to use on outgoing connects! PORT X .... Config .... MYcall KI0BK

I'm glad you've found the problem but it shouldn't segfault so I'll look at that. 73, John

Ok, found the problem..... I had a forward script where a couple of lines started with a # Something like this... #att 1 #c gb7iow #bbs This gives a seg fault... If you have something like this...

Can you look in the BBS log and see if it has recorded the call of the bbs it is trying to connect to. The segfault may have disrupted the logging, but if not disable forwarding the the bbs it was

So I have good news, *IT'S WORKING!* Adding the command RIGCONTROL the option of *DATAPTT* that I found used for radios with internal sound card like the Yaesu FT-991A did the trick! This is the

John Is this documentation for radio with its own internal sound card: This will switch the modulation source to Soundcard when a Sound Card modem sets PTT and return it to the AUX connector when PTT

Hi John, Just the same output... Thread 1 "pilinbpq" received signal SIGSEGV, Segmentation fault. 0x00129f98 in memicmp (a=0x0, b=0x265dc4 "TIMES", n=5) at

This turned out to be 1D10T error because of a duplicate callsign and SSID. I had tested the RMS feature for our permanent node while it was at my QTH and I had internet. When I moved it to our tower,

Jouko I did had performed your recommendations and also in the radio the MIC data volume has been set to 9, the maximum. I have been reading the radio manual and what I understood is that the RTS

Can you try running under gdb? https://www.cantab.net/users/john.wiseman/Documents/gdb.html Thanks, John

Hi Steve, Thanks, I did’t change anything recently. I removed all the times setting. I give it a try. 73 Niels

Niels It appears something is wrong with a TIMES entry in a fwd script that runs on the hour. Check those scripts and see. Not that it should segfault. 73 Steve [email protected]> wrote:

Hi, Lately I've been having? about every hour a segmentation fault with pilinbpq. I don`t understand why. Thanks. 73 Niels PD9Q Oct 24 05:30:52 pi1lap bash[19835]: /home/pi/linbpq/linbpq.start: regel

Always a possibility, but when the other side connects to me it works!?