The top R-line shows who you received the bulletin from. I would check the settings for that user (N2MH4) as well as the user for
ZS6SPY - if there is one.
The fact that you have so many of those notifications makes me suspect that you received a lot of bulletins from the same forwarding partner. I can't imagine that all of those messages originated from ZS6SPY. You should not have the hold messages flag set on a user that applies to a forwarding partner. If
N2MH4
is not supposed to be a forwarding partner, then you should uncheck the BBS box in the settings for that user.
73,
Lee K5DAT
On Fri, Apr 11, 2025 at 9:32?AM Christopher Molnar KO4YAW via <cmolnar65=[email protected]> wrote:
I have the BPQ32 going, Question with the Baycom in the BPQ must I add the settings for Baycom. I have used the old BPQ on my pervious FBB system. I will get it going like i said I used it more than 20 year ago slowly pickup where I left off LOL, my memory is sometimes liek a a hardrive that crashed busy with recovery LOL.
Best 73 Pieter ?
USE WINFBB 7.01.35 AGW WITH SOUNDCARD,TELNET,TCP/IP,INTERNET FORWARDING
On Fri, Apr 11, 2025 at 10:23 AM, Chuck Gelm wrote:
On 4/11/25 10:08, Christopher Molnar KO4YAW via wrote:
Good morning!
Can anyone share the secret in figuring out what user has the hold message flag set in this case? These messages are showing up for every bulletin message my node receives and almost makes finding messages I am looking for impossible.
?
Thank you!
-Chris KO4YAW
Hi, Chris:
Tell us about message #3817. Tell us about who it is from and addressed to whom.