RESOLVED
After beating this to death, I discovered that the problem was the
parameter specification.
The documentation shows in the scan lines section...
F1-F3 - IF Filter for ICOM Rigs
So I was using..
RADIO 7 14.1075 LSB F1 W
Sorry?-?Set?Mode?Command?Rejected
A bit lower there is a different format for command line entry
RADIO Freq Mode Filter eg RADIO 14.112 USB 2 (ICOM)? ...note No "F"
Now If I send...
RADIO 7 14.1075 LSB 1 W0
Frequency?and?Mode?Set?OK
Now, all the parameters are accepted.
73,
Rick VA7RBP
On 2023-05-04 1:18 p.m., Rick Paynter VA7RBP wrote:
toggle quoted message
Show quoted text
Well...I get
RADIO 7 14.1075 LSB F1 W
Sorry?-?Set?Mode?Command?Rejected
Rick VA7RBP
On 2023-05-04 11:24 a.m., John G8BPQ
wrote:
The fields in a RADIO command (unlike scan lines) should be
separated by spaces - RADIO 7 14.105 LSB F1W
73,
John
On 04/05/2023 16:33, Rick Paynter
VA7RBP wrote:
Hi All
I'm having some trouble trying to set up Rig Control using
PILINBPQ VER 6.0.23.63
Radio is ICOM IC-756PROIII
It appears that the only parameter that gets sent to the radio
is the frequency, when I issue...
RADIO 7 14.105,LSB,F1,W
Frequency changes OK, but SB remains USB, and nothing else
changes.
My port configuration, so far...
;
;? Port 7? SCS PTCII USB
;
PORT
?PORTNUM=7
?ID=PACTOR
?COMPORT=/dev/ttyUSB1
?SPEED=19200
?DRIVER=SCSPactor
?PORTCALL=VA7RBP
?INTERLOCK=1
?CONFIG
?RIGCONTROL
?/dev/ttyUSB2 19200 ICOM IC756 6E
?PSKA 140? ? ? ? ? ? ? ?; PSK TX Output level.
?FSKA 100? ? ? ? ? ? ? ?; TX Level for FSK modes.
?PAC BAUD R300
?SCANFORROBUSTPACKET 7
***?
ENDPORT
?
Is this a bug in pilinbpq, or do I have a config issue?
Any suggestions?
Thanks,
Rick VA7RBP
