Thanks Perry. Its working now with John's instructions using
alsamixer. You're right, I just had to tweak the audio to key the
SL-Radio. However now I have a port conflict? with KAM and Signal
Link...
I will get there; I may not have hair left.; but thats the fun,
pulling you hair out.....:)
Brett
On 6/12/2022 9:43 AM, Perry Ogletree
wrote:
toggle quoted message
Show quoted text
The Signalink USB uses internal VOX keying. Your
audio level of the Signalink's internal sound device must be set
high enough to trigger the VOX. If you have CAT control of the
radio, you'd be better off using CAT PTT to key the radio.
Perry K4PWO?
Sent from my
T-Mobile 4G LTE Device
Get
Thanks Lee and John. I have the Program working well and
receiving packet. The only issue im having now is transmit.
QtSoundModem is receiving the command from QtTerm TCP, however
the signallink is not keying. Is there an extra driver for the
signal link?
On 6/10/2022 12:09 PM, Lee
Bengston wrote:
Brett,
The sudo commands I provided were the "extra's" needed
for compiling, but in hindsight you were probably missing
the standard prerequisites for running the binary version.
It's all documented nicely here:
Good to know you have it working.? John was right in
saying it's easier to just download the binary version and
run it, and I should have mentioned that yesterday.
73,
Lee K5DAT
On Thu, Jun 9, 2022 at
11:38 PM Brett Williams <
KB5YZB@...> wrote:
Thanks
I ran the SUDO command successfully.
I also have the file unzip on the pi.
I issued the "qmake" command and the following is
reported...
qmake: could not find a Qt installation of ''
Lee Im not sure what went wrong.......
