No, but make sure you've selected the right audio device in QtSM and
that there is sufficient audio drive to trigger the PTT circuit on
the SignaLink. Check the audio levels - I use alsamixer.
73,
John
On 12/06/2022 05:06, Brett Williams
wrote:
toggle quoted message
Show quoted text
Thanks Lee and John. I have the Program working well and
receiving packet. The only issue im having now is transmit.
QtSoundModem is receiving the command from QtTerm TCP, however
the signallink is not keying. Is there an extra driver for the
signal link?
On 6/10/2022 12:09 PM, Lee Bengston
wrote:
Brett,
The sudo commands I provided were the "extra's" needed
for compiling, but in hindsight you were probably missing
the standard prerequisites for running the binary version.
It's all documented nicely here:
Good to know you have it working.? John was right in
saying it's easier to just download the binary version and
run it, and I should have mentioned that yesterday.
73,
Lee K5DAT
On Thu, Jun 9, 2022 at
11:38 PM Brett Williams <
KB5YZB@...>
wrote:
Thanks
I ran the SUDO command successfully.
I also have the file unzip on the pi.
I issued the "qmake" command and the following is
reported...
qmake: could not find a Qt installation of ''
Lee Im not sure what went wrong.......
