John, et al...
I have one install that although is connected to the internet it is only for my convenience and not for traffic or any public connections. Ever,
I run RMS Relay in the local post office mode along side of BPQ so that it holds all messages. Nothing is ever forwarded to the internet or over RF.
I have it working fine, and has been for years, but I would like to change it so that the BBS acts as relay. It must hold all messages and never, ever try to forward them.
The present config file includes this in the Telnet port:
?? CMS=1????????????????????????????? ;;;;;;;;;;;;;;;;;;;;
?? CMSCALL=WA5EOC???????? ;; Are these even necesary?
?? CMSPASS=xxxxxxxxx????????? ;;;;;;;;;;;;;;;;;;;;;
RELAYHOST=10.109.47.133 8773
And the Application line is this:
APPLICATION 3,RELAY,C 3 RELAY,WA5EOC-10,EOCRMS,0
Relay is set to accept connection on
10.109.47.133 on port 8773
Again all works well, I just need to change it so that the BBS acts as relay.? I'm working remotely so I thought it much easier to ask and fix it in one remote session rather than trial and error, and error, and error....
And an FYI, changing out the computer is what solved my RF connection issue. No clue what it was....
Thanks
Mark
