Re: atlas 10" quick change tool post
|
No, that's the point I was trying inadequately to make above.? Each designation (AXA, BXA, etc) MUST take tool holders made exclusively for them.? It took ME? a LONG time to figure this out myself, and oldsters who already know this scoff at us ignoramuses, but try as I might, I could not find a direct answer to what these designations are.? But I know now.
As far as the Aloris style tool POST goes, it has a sliding WEDGE that holds the tool holder in place.? There is another style that has a PISTON that pushes out and presses the back side of the tool holder.? That type is simpler--that is the style I would make if I were to make one.
|
