Re: Motor wiring question

Bill in OKC too All Messages By This Member #116705 Still less current draw across a set of contacts. Which makes for longer useful life of that set of contacts. Bill in OKC William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by: Good judgement comes from experience. Experience comes from bad judgement.? SEMPER GUMBY! Improvise, Adapt, and Overcome. Physics doesn't care about your schedule. The only reason I know anything is because I've done it wrong enough times to START to know better. Expect in one hand, expectorate in the other. See which one gets full first. On Wednesday, June 12, 2024 at 07:22:14 PM CDT, Ralph Hulslander <rhulslander@...> wrote: re: " A 3/4HP motor at 120VAC draws about 4.67amps, for about 560watts of power. The same motor on 220VAC draws about 2.5 amps for the same power." The 220 VAC draws about 2.5 amps per leg! 220 VAC uses two legs or hot wires! Ralph toggle quoted message Show quoted text On Mon, Jun 10, 2024 at 5:12?PM Renaissance 1 via <nthomas9418=[email protected]> wrote: If the machine is hard wired then a disconnect would make sense Sent from phone On Jun 10, 2024, at 1:09?PM, Ken H <dreamcrafters@...> wrote: ?I like to leave just a little slack in the belt tension as a safety clutch, I'd much rather have that slip than break something. -- Ken H in AZ Knowledge is like manure, it won't do any good unless you spread it around.

Join [email protected] to automatically receive all group messages.

开云体育