¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Atlas-Craftsman
  2. Messages
Single Messages Topics Expanded Polls

Re: I Need a 3 Jaw Chuck

 

This chuck one has to make the adapter plate. I hope the one that buys it knows how

GP


On Saturday, April 18, 2020, 5:48:54 PM EDT, Andrei <calciu1@...> wrote:


If that does not work, you can check this one out next:

Typos are courtesy of autocorrect.

From: [email protected] <[email protected]> on behalf of Jody <jp4lsu@...>
Sent: Saturday, April 18, 2020 4:27:59 PM
To: [email protected] <[email protected]>
Subject: Re: [atlas-craftsman IO] I Need a 3 Jaw Chuck
?
I rolled the dice on ebay and found an Atlas 3 jaw.? $115 after shipping.? I'll see how it works in a week or so.
-Jody?



Sent via the Samsung Galaxy S10+, an AT&T 5G Evolution capable smartphone


-------- Original message --------
From: Chris <chrisandjudy@...>
Date: 4/18/20 3:09 PM (GMT-06:00)
Subject: Re: [atlas-craftsman IO] I Need a 3 Jaw Chuck

?
?
I went to ebay for a used one. Took a little searching but found one that looked okay for a little over a hundred dollars plus shipping.
It arrived and I put it on my lathe and it checked out .005 out.? I had reground the jaws in another chuck and was pleased so I ground the jaws on
this one and it turned out less than .0015 run out.? The reason for buying another 3 jaw chuck was so I could have one set up for inside holding
and one for outside holding.? I also bought separate jaws sets from ebay and that was a crap shoot but did allow me to save a good chuck with very bad jaws.
Chris in WA
Join [email protected] to automatically receive all group messages.