开云体育

What no-one has answered is whether you already have a sleeve or not ?

The MT3-2 sleeve allows you to use a variety of MT-2 tooling in the
spindle , and an MT-2 centre will also fit the tailstock . . . .

If you intend to do centre to centre operations then a MT-3 and an
MT-2 would be needed

Regards,

Carvel

*From:*[email protected] [mailto:[email protected]]
*On Behalf Of *Robert Downs via Groups.Io
*Sent:* 06 February 2019 11:58 PM
*To:* [email protected]
*Subject:* Re: [atlas-craftsman IO] Dead Center

Short answer is “yes”. A 3MT dead center will work fine in the spindle.

Robert Downs

*From:*[email protected] [mailto:[email protected]]
*On Behalf Of *Stan Gorodenski
*Sent:* Wednesday, February 6, 2019 14:46
*To:* [email protected]
*Subject:* [atlas-craftsman IO] Dead Center

The manual for my Atlas 10" says a sleeve is provided to go from a #2
Morse taper to a #3 Morse taper. I know little about machining and so I
don't know if this means I could buy a #3 Morse dead center and directly
put it in the headstock spindle and eliminate the sleeve. Would I be
able to do this, or could there still be some problems in the taper of
the bought dead center not matching like it should to the taper in the
headstock?
Stan