开云体育

So I didn't adhere to the old adage of measure twice cut once.? Actually I didn't even measure in one instance.

I had some 1/2" bar left over from another project I did for a guy, which was some brass electrical connectors for a 1929 Chrysler.? Little bitty knit picky bits.

With extra brass, I decided i'm done with the little set screws on the dials and thought I'd make a thumb screw for the cross slide and compound.? I measured what a good size would be for the cross slide and made 2 of them.? I didn't even look and measure if it would work on the compound, since they are similar.

The cross slide screw came out great and when I put on the thumb screw on the compound the large OD thumb portion contacts the OEM fastener head that holds the end cap for the thrust bearing.? A sample pic is attached. It's not my part but it is the same screw driver head as mine.

I'm thinking? of a couple options.

1)? Trim the length of the thumb screw and maybe even the thickness of the thumb portion so that it will sit low enough to get by the raised screw head of the fastener holding the bearing end plate on the compound.?
2)? Take the bearing plate off and counterbore it so that the fastener head sits flush.? The chrome is gone, it is now powder coated.

I'm pretty sure #1 will work.? I need to get back out there and measure.? Thinking about this i may actually trim the length of the cross slide thumb screw to get it closer to the dial.? It sits proud a few threads.

Just curious what you guys thought or to see what you guys had or if you had another option.?
Thanks,
Jody